如何查看CentOS的网络带宽出口

2019/8/5 9:24:00

检查维护系统的时候,经常会要查看服务器的网络端口是多大的,所以需要用到Linux的一个命令。
如何查看CentOS的网络带宽出口多大?可以用下面的命令来查看。
 
 
# ethtool eth0
 
前面是命令,后面跟的是设备名,如果对外连接的网络设备是eth1,那就需要改成:ethtool eth1
 
[[email protected] ~]# ethtool eth0
 
Settings for eth0:
        Supported ports: [ TP ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Full
        Supported pause frame use: No
        Supports auto-negotiation: Yes
        Advertised link modes:  10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Full
        Advertised pause frame use: No
        Advertised auto-negotiation: Yes
        Speed: 1000Mb/s
        Duplex: Full
        Port: Twisted Pair
        PHYAD: 0
        Transceiver: internal
        Auto-negotiation: on
        MDI-X: Unknown
        Supports Wake-on: d
        Wake-on: d
        Current message level: 0x00000007 (7)
                               drv probe link
        Link detected: yes

处理 SSI 文件时出错